Removing The Bell From The Tube; Removing The Blades; Whisk; Attaching The Whisk Holder To The Motor Unit - Robot Coupe CMP 250 V.V. Manual De Instrucciones

Removing the bell from the tube

- Unplug the immersion blender.
- Turn the bell in the direction of the arrow 1 (see
next figure) to separate the bell lug E from the
tube lug F.
- Remove the bell.
- If jammed, turn the blades inside the bell in the
direction of the arrow 2 to loosen them from the
drive shaft.

Removing the blades

- Unplug the immersion blender then, hold
the blades with the provided blade-locking
tool.
- Using the blade-locking tool, unscrew the
drive coupling then remove the blade for easy
cleaning.
8
01/06/2021
B
LADE LOCKING
B
LADES WITH WATERTIGHT SEALS
B
ELL
D
RIVE COUPLING
B
LADE REMOVAL

• WHISK

Attaching the whisk holder to the motor unit

(only for CMP Combi)
C
B
- Unplug the Immersion Blender.
- Align the flat side A of the conical part C of the
whisk holder with the catch B on the inside of the
aluminum casing.
- Insert the conical part C of the whisk holder into
the aluminum casing.
- Turn the whisk holder in the direction of the
arrow (see figure) until it is snugly locked into
place.

Removing the whisk casing

- Unplug the Immersion Blender.
- Turn the whisk holder in the opposite direction
from that used to attach it.
- When it will go no further, remove the whisk
holder from the aluminum casing.

Fitting the whisk into the whisk holder

A