Home Decorators Collection FLORA 60 GBSH163 Manual De Instalación página 4

• Measure the thickness of your finished surface on either side before installing the metal tracks.
• Make sure to have a finished surface distance (D) between the min and max permissible dimensions according to the table
below.
*IMPORTANT: Your shower is designed to accommodate a 1 13/16 in tolerance from the maximum value. If needed you
FINISHED SURFACE OPENING (D)
Support bar adjustability
MIN**
54 5/8 in
**If you require to cut the bar, refer to the calculation below:
1. Measure the distance "D" at the height where the bar will be installed.
2. Cut the bar to a total length of L = D - 3 3/8 in
3. The maximum measure to cut from the bar should be no more than 3 9/16 in
WALL-TO-WALL DIMENSIONS
can cut the support bar to fit the shower.
D
MAX*
60 in
WARNING!
SHOWER DOOR HEIGHT
(Make sure the door height is not surpassing your tile /
acrylic wall height)
74 in
L
L = D - 3 3/8 in
PAGE 4