Idiomas disponibles
Idiomas disponibles
SEAT COVER AND HEADREST:
INSTALLATION:
Pull the seat cover over the frame and fasten the flaps on the back. To attach the headrest, the Velcro flap
should go through the loop located on the top of the seat cover.
REMOVAL:
To take off the seat cover simply detach the flaps, and pull out the fabric of the metal frame.
TOYBAR AND TOYS:
INSTALLATION:
To attach the toys to the canopy simply pull the Velcro flap through the two possible loops. Once the toys
are connected to the toybar, fasten the clasps on the swing frame on both sides.
REMOVAL:
Pull out both clasps of the toybar to remove it.
NOTE: the seat cover has small fabric flaps which reveal the metal frame. Thanks to this, the toybar is more
securely attached to the frame. After the toybar net has been removed, the flaps should be closed to hide
access to the frame.
SAFETY BELT INSTRUCTION:
Place the baby into the bouncer and remember to adjust the seat belt on both sides equally. The buckle of
the safety belts is located in the crotch support restraint. It can be easily accessed by pulling on the Velcro
attachment.
NOTE: Make sure that the safety belt is fitted for the child.
WARNING: To ensure the safety of the child make sure that the safety belt is properly connected to the
buckle before using the bouncer.
MOTION LOCK:
Push the motion lock down to lock the bouncer in the starting position. Pull the motion lock up to unlock
the rocking motion.
WARNING: do not try to engage the lock while the bouncer is in motion.
POWER SUPPLY:
Plugin the adapter into the swing. The socket is located on the inside of the leg.
A. DC plug can be inserted into 100-240V ~ 50 / 60Hz AC power supply.
B. Adapter output parameters: voltage is 5V and current is 1A.
C. The adapter has a 2m long USB cable.
BATTERY INSTALLATION:
The battery compartment is located at the end of the swing base, on the opposite leg with the speaker, it is
marked with a battery icon. To open the compartment, unscrew the screws and remove the cover. Insert 4
pcs of AAA batteries and screw back the cover.
To replace the batteries in the remote control, follow the drawing on the back of the remote control. Press
the button and slide out the battery compartment.
EN
11
