Idiomas disponibles
Idiomas disponibles
Installation
Positioning the appliance
Positioning the appliance in the desired location. The back of the appliance should rest against the wall,
and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and
drain hoses that can be positioned to the right or the left to facilitate proper installation.
Levelling the appliance
Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the dishwasher,
making it level. The appliance should not be inclined more than 2˚. If the appliance is level, it will help
ensure proper performance.
Cold water connection
Connect the water supply hose to a threaded 3/4 (gas) connector,
making sure that it is fastened tightly in place (see fig.A).
Some models are fitted with an "Aquastop" water supply hose (see
fig.B) in which the small filter is already housed in the threaded
end.
If the water pipes are new or have not been used for an extended
period of time, let the water run to make sure that the water is
clear and free of impurities. If this precaution is not taken, there
is a risk that the water inlet can get blocked and damage the
appliance.
Warning
The appliance is to be connected to
the water mains using new hose-sets
and that old hose-sets should not be
reused.
Anti-Flooding protection
The dishwasher is equipped with a system that stops the supply of water in the event of a problem with the
water supply hose, or leaks within the unit, in order to prevent damage to your home. If for any reason the
box containing the electrical components happens to get damaged, turn off the power supply and remove
the plug for the appliance from the socket immediately. In order to guarantee that the anti-flooding feature
operates properly, the "A" box with water supply hose must be attached to the water supply tap as shown in
fig.B. No other type of connection is acceptable.The water supply hose must not, under any circumstances,
be cut, as it contains electrical parts which are live. If the length of the hose is not adequate to make a
proper connection, the hose must be replaced with one which is long enough. This hose is available upon
request from specialised retailers and approved service center.
6
All manuals and user guides at all-guides.com
EN
fig.A
fig.B
