EN
This manual contains important information that should be kept for future reference.
Self-assembly.
Warning! Keep children away from the assembly area.
Leave the plastic bags out their reach. The small parts pose a choking hazard.
Materials
15MM, 18MM, 25MM Particle Board, 2.5MM, 25MM MDF.
Assembly Instructions
Before beginning assembly, identify all components using the manual.
In order not to lose components, do not throw the package before completing the full assembly.
This product must be assembled by an adult.
Plan to assemble the furniture as near as possible to where you want to install.
Assemble on a clean, flat surface.
Recommendations for use
This product is designed for indoor use only.
Beware of sharp objects.
WARNING "High beds and the upper bed of bunk beds are not suitable for children under six years
due to the risk of injury from falls".
WARNING "Bunk beds and high beds can present a serious risk of injury from strangulation if not
used correctly. Never attach or hang items to any part of the bunk bed that are not designed to be
used with the bed, for example, but not limited to ropes, strings, cords, hooks, belts and bags".
WARNING "Children can become trapped between the bed and the wall. a roof pitch, the ceiling,
adjoining piece of furniture (e.g. cupboards) and the like. To avoid risk of serious injury; the distance
between the top safety barrier and the wall shall not exceed 55mm or shall be more than 230 mm".
WARNING " Do not use the bunk bed/high bed if any structural part is broken or missing".
WARNING" Risks of fall attention to downside form the platform".
Always follow the manufacturer's instructions; Any wrong assembly of the platform different from the
instruction guideline may cause danger.
Recommended size of the mattress(es): 900 × 1900 × 160mm
Ventilation of the room is necessary in order to keep the humidity low and to prevent mould in and
around the bed.
Check regularly that all assembly fastenings are properly tightened.
The bed meets the requirements of the standard: EN747-1:2012+A1:2015 & EN747-2:2012+A1:2015.
Maintenance
Remove dust regularly with a dry cloth.
Clean with a soft, damp cloth. Then wipe with a clean dry cloth.
Wipe up spills immediately with a clean, dry cloth.
To prevent scratching, do not use a sponge or recurrent grains detergent.
Do not use abrasive products.
The use of special products for the wood is not necessary or recommended.
Do not place the product near a heat source (radiator, fireplace, ...) nor a moisture source. Heat and
humidity may damage the product.
In order not to damage the surface, it is recommended not to deposit hot nor wet items directly on the
top.
To avoid the appearance of marks, do not leave stationary object for more than two months.
Clean with movements in the direction of the wood fibers.
