Idiomas disponibles
Idiomas disponibles
EN
Accessing the Web User Interface
By default, the QSW - M7308R-4X switch series support DHCP clients. When connected to a network, the
switch automatically obtains an IP address from a DHCP server. You can then use Qfinder Pro (https://
www.qnap.com/en/software/qfinder-pro) to locate the switch and access QSS.
If the device is unable to connect to a DHCP server to obtain an IP address, you can access the web user
interface by changing the IP address of the computer to 169.254.100.102.
Note : Ensure that you change the IP address of the computer to its previous setting after configuring the switch.
The default IP address of the switch is 169.254.100.101.
Logging into the Web User Interface
Default username : admin
Default password : The default password is the first MAC address in uppercase letters without special
characters. For example, if the first MAC address is 00-08-9B - F6-15-75, then the admin password would
be 00089BF61575.
LED Behavior
1
3
4
5
7
9
11
Status
1
2
3
4
6
8
10
12
Locator
25GbE
2
LED
Status
• The device is ready.
• The firmware is updated.
Green
• The password has been reset.
• The device has been reset to factory default settings.
• The device is being initialized.
• The firmware is being updated.
Important: When updating the firmware, do not remove the power cord,
Flashes green
System Status
and do not force-exit the application.
• The device is being reset.
• The device password is being reset.
Flashes red
A network error occurred.
• The device is powered off.
Off
• The device is ready for password reset.
• The device is ready for factory reset.
The switch is being located.
Flashes amber
Note: The locator LED flashes for 30 minutes when the locator function
Locator
is enabled.
Off
The locator function is disabled.
Green
The network connection is operating using single-lane mode at 100 Gbps.
(First LED)
Flashes green
Data is being transmitted.
(First LED)
Amber
100 Gigabit
The network connection is operating using quad-lane mode at 25 Gbps.
(All four LEDs)
QSFP28
Flashes amber
Data is being transmitted.
(All four LEDs)
• There is no cable connected to the port.
Off
• The port is disabled in QSS.
• A network loop was detected and loop protection has disabled the port.
Green
The network connection is operating at 25 Gbps.
Flashes green
Data is being transmitted.
Amber
The network connection is operating at 10 Gbps or 1 Gbps.
25 Gigabit
SFP28
Flashes amber
Data is being transmitted.
• There is no cable connected to the port.
Off
• The port is disabled in QSS.
• A network loop was detected and loop protection has disabled the port.
Amber
The management port is operating as an uplink port.
Management
Flashes amber
Data is being transmitted.
RJ45 Link and
Activity LED
Off
There is no network connection.
Green
The network connection is operating at 1 Gbps.
Amber
The network connection is operating at 100 Mbps.
Management
Flashes green
RJ45 Speed LED
Data is being transmitted.
or amber
Off
There is no network connection.
5
6
Description
