Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS (Continued)
4.
From underneath the sink, secure the faucet body (A) to the
sink using the rubber gasket (CC), washer (BB) and quick-install
mounting nut (AA). Push the quick-install mounting nut (AA)
upwards over the faucet shank (4.1) until it is pressed firmly
against the underside of the sink and turn to tighten. Do not
overtighten.
NOTE: It is helpful to have a second person hold the faucet in
place while tightening the quick-install mounting nut.
Hardware used
Quick-install
AA
mounting nut
Washer
BB
Rubber gasket
CC
5.
Attach the end each integrated the hot water and cold water supply
line (5.1) coming from the faucet body (A) to the hot water and
cold water supply valves (5.2) under the sink, after making sure
the supply valves (6.2) are clear of any debris. Thread the nut on
the end of each integrated water supply line (5.1) onto the outlet
of each water supply valve (5.2) and tighten with a wrench. Do not
overtighten.
NOTE: Do not use PTFE pipe tape, plumber's putty, pipe dope, or
any other type of sealing compound on the water inlets or threads.
Additional compound is not necessary. A watertight seal between
the supply valve and the nut on the integrated supply line is
achieved by compression.
6.
Once the installation is complete, remove the spray head (6.1)
from the spout (6.2) on the faucet body (A) to flush the water
lines. Turn on the water supply and allow both hot and cold
water to run for at least one minute to flush away any debris
that could cause damage to internal parts. While the water is
running, check for leaks. If a leak occurs, gently tighten the nut on
the connection that is leaking. Turn off the water and thread the
spray head (6.1) back onto the spout (6.2) of the faucet
body (A).
x 1
x 1
x 1
5
4
A
4.1
CC
BB
AA
5
5.1
5.2
6
6.2
6.1
A
