Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
Run-In before Operation
For optimum performance, allow your new Flexible Driver attachment to run at high speed on
your rotary tool in a vertical position with no load for 2 minutes before use (Fig. 1).
Disengagement of the Flexible Driver
The flexible shaft may become disengaged if the motor of your rotary tool is not elevated higher
than the working end of the Flexible Driver.
Flexible Shaft Lubrication
The Flexible Driver should be lubricated after every 25-30 hours of use. To lubricate, unscrew
the Flexible Driver assembly from the motor housing. Pull the center core out of the Flexible
Driver assembly. Wipe a very thin film automotive wheel bearing grease on to the center core
and reinsert it back into the shaft. To prevent damage to tool do not over grease shaft.
Too much grease will cause the unit to overheat.
Reattach the Flexible Driver to the rotary tool using instructions provided on page 12.
Cleaning and Maintenance
Always pull out the main power plug before starting any cleaning work.
•
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the
equipment with a clean cloth or blow it with compressed air at low pressure.
•
We recommend that you clean the device immediately each time you have finished using it.
•
Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the
device.
•
There are no parts inside the equipment which require additional maintenance.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice
WWW.FORNEYIND.COM
13
