CONTROL
PANEL
Your dehumidifier control panel contains a Bucket Full indicator, a Humidity indicator, a Power
Control, Humidity Control, Fan Speed Control and Timer Control.
Bucket Full indicator
---This light glows when the water bucket is full and needs to be emptied.
Power --- Operation starts when this button is pressed and stops when the button is pressed again.
Humidity Control --- This button controls the humidity in the room.
• @ : To raise the humidity setting
• Q : To lower the humidity setting
• The humidity can be set within a range of 35% RH(Relative Humidity)~70%
RH(Relative Humidity) by 5% increments.
Fan Speed --- This controls the speed of the airflow.
• High: Fan speed is set to high.
• Low: Fan speed is set to low.
• When Fan Speed button is pressed, the fan speed mode is changed.
Energy Timer --- Press this button to select type of operation.
• Select Constant for uninterrupted operation.
• Select either 2 or 4 Hr. On/Off for cycled operation.
The unit will operate for 2 or 4 hours, and then shut off completely for 2 or 4 hours.
The cycle repeats until you change the setting.
• When Energy Timer button is pressed, the Timer indicator lights shift as follows:
Continuous -) 2 Hr. On/Off e. 4 Hr. On/Off -) Continuous.
Auto Restart--- Once power is restored after a power outage, the unit returns to its previous operation
settings after a 2 minute delay.
The fan runs immediately, when the power is restored.
TO OPERATE THE DEHUMIDIFIER:
1. Plug the power cord into an electrical outlet. Press the power button.
2. Set the Humidity Control anywhere between 35% RH(Relative Humidity) and 70% RH(Relative Humidity)
for normal operation.
If you prefer drier air, press the Humidity Control button.
If you prefer more humid air, press the Humidity Control button.
3. Press the Power button to stop the unit manually.
4. Press the Timer button to set the amount of time you want the unit to run.
At the end of that time, the unit will shut off.
The Timer can be set for : Continuous, 2 hours or 4 hours.
5. If you want to control the speed of airflow, press Fan Speed button. Each time that the Fan Speed button
is pressed,the fan speed mode is shifted: High -) Low -) High
Note: Be careful not to lose the water bucket.
This dehumidifier will not operate if the water bucket is not installed properly.
/
-7-