Idiomas disponibles
Idiomas disponibles
7. USE
7.1 ON/OFF
Before plugging in the tool, always check to see that the switch trigger actuates properly
and returns to the "OFF" position when released.
7.2 OVERLOAD CLUTCH
If the tool insert becomes caught or jammed, the drive to the drill spindle is interrupted.
Because of the forces that occur, always hold the power tool firmly with both hands and
provide for a secure stance.
If the power tool jams, switch the tool off and loosen the tool insert. When switching the
tool on with the drilling tool jammed, high reaction torques can occur!
WARNING! If the power tool jams, switch it off immediately to
prevent premature wear of the tool.
7.3 SPEED/IMPACT RATE CHANGE
The rated speed and impact rate can be adjusted just by turning the adjusting dial 10.The
dial is marked MIN (lowest speed) to MAX (full speed).
Refer to the table below for the relationship between the number settings on the
adjusting dial and the rated speed/impact rate.
No. Adjusting Dial
WARNING!
• If the tool is operated continuously at low speeds for a long time ,
the motor will get overloaded , resulting in tool malfunction.
• The speed adjusting dial can be turned only as far as MAX and back
to MIN. Do not force it past MAX or MIN, or the speed adjusting
function may no longer work.
To start the tool, press the On/Off switch 5 and hold it.
To switch off the tool, release the On/Off switch 5.
In low temperatures, the tool reaches the full hammer/
impact capacity only after a some time.
No-load speed (rpm)
33
Impact rate (bpm)
