Idiomas disponibles
Idiomas disponibles
Power
Supply Cord Kit (U.S.A.)
The user is responsible for connecting the power supply
cord to the connection block located behind the back
panel access
cover•
This appliance may be connected by means of
permanent "hard wiring" (flexible armored or
nonmetallic
shielded copper cable), or by means of a
power supply cord kit. Only a power supply cord kit rated
at 125/250 volts minimum, 40 amperes and marked for
use with ranges shall be used. See chart for cord kit
connection opening size information• Cord must have
either 3 or 4 conductors•
For mobile homes, new installations, recreational
vehicles, or areas where local codes do not permit
grounding through neutral, a 4 conductor power supply
cord kit rated at 125/250 volts minimum, 40 amperes
and marked for use with ranges should be used (see
Figure 5).
Terminals on end of wires must be either closed loop or
open-end spade lugs with upturned ends. Cord must
have strain-relief clamp•
See below for 3 or 4 conductor wire connection•
Range Connection
Opening Size Chart
Refer to chart below for proper range connection opening size and power
supply cord kit ampere rating information. Seeserial plate on appliance for
kilowatt rating data.
See serial Plate on the
Appliance
for KW Rating
120/240
Volts
120/208 Volts
0 - 8.7 kw
0 - 7.8 kw
8.8-16.5kw
7.9-12.5kw
16.6- 22.5 kw
12.6-
18.5 kw
Cord Kit
Ampere
Rating
30 Amp
40 Amp
50 Amp
Diameter (inches (cm)) of
Appliance Connection
Opening
Direct
Cord Kit
Connection
1 1/8 (2.9)
7/8 (2.2)
1 3/8 (3.5)
1 1/8 (2.9)
1 3/8 (3.5)
1 3/8 (3.5)
NOTE: Electric Slide-in Range is shipped from factory
with 1 1/8" (2.9 cm) dia. hole as shown on figure 4. If a
larger hole is required, punch out the knockout.
Risk of fire or electrical
shock exists if
an incorrect size range cord kit is used, the
Installation
Instructions
are not followed,
or the
strain relief bracket
is discarded.
• . . Style
Figure 1
Do not loosen the nuts which secure
the factory-installed
range wiring
to terminal
block
while
connecting
range.
Electrical
failure
or loss of
electrical
connection
may occur.
F Factory
Connected
Power
Supply
Cord (Canada
only)
This range is equipped with a factory-connected
power
cord (see Figure 2). Cord must be connected to a
grounded 120/240 volt or 120/208 volt range outlet. If
not outlet is available, have one installed by a qualified
electrician•
Canada Style
Figure 2
Electrical Shock Hazard
• Electrical
ground
is required
on this appliance.
• Do not connect to the electrical
supply
until
appliance
is permanently
grounded.
• Disconnect
power
to the circuit
breaker or fuse
box before
making the electrical
connection.
• This appliance
must be connected
to a
grounded,
metallic,
permanent
wiring
system,
or a grounding
connector
should
be connected
to the grounding
terminal
or wire lead on the
appliance.
Failure to do any of the above could result in a
fire, personal injury
or electrical
shock.
