Idiomas disponibles
Idiomas disponibles
CASTER INSTALLATION
1.
Lay unit upside down. Remove screws and panel on
bottom of unit using Phillips screwdriver. (See Figure 1)
Figure 1
2. Remove all parts (casters, hose adapter, hardware)
from compartment. Replace compartment cover
when finished.
3. Install casters using Phillips screwdriver and four
screws per caster. (See Figure 2)
NOTE: Ensure locking casters are installed at
front of unit.
Figure 2
PAGE 2 OF 12
SETUP
FILLING THE TANK
NOTE: Unit must be in an upright and level
position before filling.
HOSE FILL
NOTE: Do not use hose adapter indoors.
1. Connect hose adapter to plastic grommet on bottom
left side of unit. Rotate hose adapter clockwise to
secure. (See Figure 3)
Figure 3
Hose Adapter
2. Connect a standard garden hose to hose adaper.
3. Turn water on low to fill tank. Once tank is 1/4 full, the
float will stop the flow of water.
MANUAL FILL
1.
Press in on center of tank door to open. (See Figure 4)
Figure 4
Tank
Door
2. Fill tank with up to 10 gallons of water. Repeat step 1
to close door.
0124 IH-11188
