Idiomas disponibles
Idiomas disponibles
Mounting tool bits
Warning: before do it, make sure unplug the machine!
Inserting
Clean and lightly grease the shank end of the tool. Push back the Flex Sheath and insert the the tool. Pull the drill bit to make
sure it is locked completely.
Removing
Push back the Flex Sheath and remove the tool.
CAUTION: The insert tool may become hot during Use. There is a risk of burning the hands. Wear protective gloves when
changing insert tools.
How to replace grease
This machine is if full air-tight construction to protect against dust and to prevent lubricant leakage. Therefore, the machine
can be used without lubrication for long periods. Replace the grease as described below.
CAUTION:
Before replenishing the grease, turn the power off and pull out the power plug.
1. Loosen the four set screws and remove oil tank cover. Wipe off the grease inside.
2. Supply 30g of Demolition Hammer Grease (Standard accessory, contained in tube) to the crank Housing. Too more or too
little will cause the machine non-properly work.
3.After replenishing the grease, Install the oil tank cover Securely.
4.Clean the machine
Tool
②
Flex sheath
①
Fan cover
①
Tool
②
Flex sheath
①
Grease 30g
7
②
YEAR
WARRANTY
1
