Idiomas disponibles
Idiomas disponibles
Maintenance and cleaning
Grease mesh filters
The mesh filters can be cleaned by hand.Soak them for about 3 minutes in water with a mild detergent
and then brush it gently with a soft brush. Do not apply too much pressure so as to avoid any damage to
it . (Leave to dry naturally out of direct sun light)
Filters should be washed separately to crockery andkitchen utensils.It is advisable not to use rinseaid.
Installing grease mesh filters
To install filters for the following four steps:
1. Angle the filter into the slots at the back of the hood.
2. Push the button on thehandle of the filter.
3. Release the handle once the filter fits into a resting position.
4. Repeat to install all filters.
Carbon filter - not supplied
Activated carbon filter can be used to trap odors. Normally the activated carbon filter should be
changed eyery 3 to 6 months according to your cooking habits. The installation procedure of activated
carbon filter is as below:
1. Before installing or replacing the carbon filters, disconnect the mains power to the unit.
2. Press the filter lock and remove the mesh filter.
3. Turn the carbon filter on both sides of the motor anti-clockwise. Replace thecarbon filters with the new
carbon filters.
4. Place the mesh filter.
5. Connect the power supply to the wall socket.
Note: Make sure the filter is securely locked. Otherwise, it would loosen and cause danger.
When activated carbon filter attached, the suction power will be lowered.
33
English
infiniton.es
