Idiomas disponibles
Idiomas disponibles
FINGERPRINT OPENING OF THE WATCH WINDER
(1) When using for the first time
When delivered, the lock can be opened by placing any finger on the sensor. It
is a battery operated lock. To supply the battery with energy, connect the watch
winder to the power supply. Then set the red toggle switch to (I).
Exterior of the watch
winder
Door
(2) Register a specific fingerprint
Press the SET button inside the watch winder. The LED on the lock will light up
green for a short time. Put the finger you want to register on the sensor several
times (5-8 times) in quick succession. The successful completion of the registration
is signalled by a constant lighting of the green LED. A maximum of 5 fingers can be
registered in this way.
(3) Opening the watch winder after registration
Place a previously successfully enrolled finger on the sensor. If the LED lights up
red, repeat the process or change your finger.
(3) Delete all registered fingerprints
To delete all registered fingerprints, press and hold the SET button for more than 3
seconds. As soon as the green LED lights up three times, all fingerprints have been
deleted and the device is restored to the delivery status.
(4) Low battery warning
If the LED lights up red three times when you open the lock, the battery needs to
be charged. Then set the red toggle switch to (I). During charging, the LED flashes
at short intervals. As soon as the green LED lights up constantly, the charging
process is complete. Then set the red toggle switch back to (0).
Interior of the watch
winder
Sensor
SET button
Red toggle switch for
charging the sensor
EN
17
