Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
WARNING
This product contains sharp edges on
the panels,cylinder housing and
handle please install with care.
1. Line up holes on the bracket of wheel kit (G) with the
.
corresponding holes on base (H), then insert M8 x15mm bolts
(AA) through holes. Hand tighten with M8 flange nuts (DD). Be
sure the wheel assembly is parallel to the base (H).
To protect heater from strong wind, anchor the base (H)
securely to the ground with screws.
a. Reverse the base (H), fix the ground bracket (PP) to the
base (H) with bolts (BB) and washers (LL) like picture shows.
b. Secure the ground bracket (PP) with nuts (HH).
c. Fix another two ground bracket
nuts (HH) , and reverse the base (H).
Hardware Used
AA
x 2
M8 x15mm Bolt
DD
x 2
M8 Flange Nut
LL
x 6
Φ6 Washer
2. Fix the base bracket (OO) to the base (H) with screws (FF)
like picture shows.
Hardware Used
M3/16in Screw
FF
OO
Base Bracket
(PP) with bolts (BB) and
BB
x 6
M6 x10mm Bolt
HH
x 6
Nut M6
PP
x 3
Ground Bracket
x 5
x 5
1
AA
BB
LL
2
OO
H
6
DD
G
HH
H
PP
FF
H
