Idiomas disponibles
Idiomas disponibles
Installation
1
Cutting the counter top
NOTE: To avoid possible damage to the cabinet, cut the
counter top before installing the counter top to the cabinet.
Affix the template (B) provided to the counter top at the
desired location with cellophane tape.
Using a pencil, mark guidelines on the counter top following
the template (B).
Drill a clearance hole approximately 1/4 in. to 1/2 in. inside
the perimeter line of the template.
Cut an opening following the perimeter line of the template (B).
NOTE: For harder surfaces, have the counter top
professionally cut following the template provided.
3
Applying the sealant
Make sure the surface to be sealed is clean, dry, soap free,
oil free, and grease free.
Apply a continuous bead of quality sealant around the top
side of the sink (A) rim near the edge.
NOTE: It is recommended to practice the proper
positioning two or three times before applying sealant.
2
Installing the anchors
NOTE:
professional.
Using the template (B) as a guide, mark the four hole
locations for the mounting hardware on the countertop.
Using a 5/16 in. diamond bit, drill a 1/2 in. deep hole in
each location.
Clean the holes and apply quick set epoxy.
Place one threaded knurl (BB) into each hole, and allow
to cure for the amount of time required according to the
epoxy manufacturer's directions.
B
BB
5
Please contact 1-855-434-5224 for further assistance.
It is recommended this be done by a
A
HOMEDEPOT.COM
