Idiomas disponibles
Idiomas disponibles
Instructions
SENSOR RANGE SETUP
The sensor range is preset at 4-3/8" [11cm] from the sensor at the factory during
assembly but can be further adjusted by using the steps below.
1.
The sensing distance is adjustable from 3/4" (2cm) to 6-11/16" (17cm). If there
is a disruption in power, the sensor range is saved and will revert to the last setting
when power is restored.
2.
The faucet sensor range is set by simply using the blue button on the front of the
control module. Do not attempt to open the control module box.
3.
Push and hold the blue button; water will flow.
After holding the button 5 seconds, the water
flow will stop and the red LED in the sensor
lens will turn on solid.
4.
Release the blue button. The red LED will turn
off signaling that the sensor is ready for set-up
for the next 15 seconds.
5.
Within 5 seconds after releasing the blue
button, hold your hand still in front of the
sensor at the desired sensor distance. The red
LED will flash roughly 5 times then remain on
for 2 seconds indicating the new range has
been set.
6.
If step 5 is not done within 15 seconds, the red
LED will blink quickly then stop indicating the
sensor range has NOT been changed. Start
over at step 3 to change the sensor range.
BATTERY REPLACEMENT
1.
Your sensor faucet requires four (4) AA alkaline
batteries. If the AC adapter is plugged in, unplug it
from its power source.
2.
Remove the battery screw and slide the battery cover
downward until it can be removed.
3.
Remove the old batteries.
4.
Install the new AA batteries, making sure that the +
and – ends are facing the correct direction. Return the
battery cover to its spot and secure with the screw. If the
AC adapter is to be used, plug it in at this time.
5.
With the disconnection of power, the sensor range is saved and will revert to the
last setting when power is restored.
4
