Childproof Lock - Zibro SRE 260 Instrucciones De Uso

Ocultar thumbs Ver también para SRE 260:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
clock
temp.
set
room
In case of any
malfunctioning the
information display will
tell you what is the
matter.
k
c ck
t mp.
set
room
key-lock
I: When the KEY-LOCK
light lights up, the
childproof lock has been
activated.
k
t
save
fuel
J: When the SAVE light
v
lights up, the heater will
automatically switch on
or off in order to remain
within a specified
temperature range.
4
48
CODE
INFORMATION
e - 0
Temperature within the heater too high.
f - 0
Power interrupted.
e - 1
Faulty thermostat.
f - 1
Faulty burner thermistor.
e - 2
Starting problems.
e - 5
Tipping-over protection.
e - 6
Poor burning.
e - 7
Room temperature
Above 27°C.
e - 8
Defective booster.
e - 9
Air filter dirty; or
Fuel pump dirty.
-- : --
Out of fuel.
(& blinking
FUEL-light)
-- : --
Too little ventilation.
(& blinking
VENT-light)
Always contact your dealer for any malfunctioning not listed above.
AUTOMATIC CLEANING MODE
When te heater has been burning continuously for two hours at its highest
setting, the burner will automatically start an autoclean procedure. The display
will show the autocleaningcode CL:05 running back to CL:00. The procedure takes
5 minutes, during which the heater will burn at its lowest setting, while the burner
autocleans. When the burner is clean again, the heater will automatically switch
back to the highest setting again.
I

CHILDPROOF LOCK

The childproof lock can be used to prevent children accidentally changing the
heater settings. When the heater is burning and the childproof lock is on, the
heater can only be switched off. Other functions are blocked then. If the heater
has already been switched off, the childproof lock also prevents accidental
ignition of the heater.
Activate the childproof lock by pressing the appropriate key
for more than 3 seconds. The KEY-LOCK indicator light will light up (Fig. I),
indicating that the childproof lock has been activated. Switch off the childproof lock
by pressing the key
J
THE CORRECT USE OF 'SAVE'
The 'SAVE' function allows you to limit the temperature. When this function is
activated, the heater will automatically switch off, when the room temperature
exceeds the set temperature by 3°C. Subsequently, when the room temperature has
dropped again to the set temperature, the heater will automatically switch on again.
Activate the 'SAVE' setting by pressing the appropriate
light will light up (Fig. J). Switch off the function by pressing the SAVE key once
again.
and holding it down for more than 3 seconds once again.
WHAT TO DO
Cool-down and re-ignite.
Re-ignite the heater.
Contact your dealer.
Contact your dealer.
Contact your dealer.
Re-ignite the heater.
Contact your dealer.
If necessary,
re-ignite the heater.
Contact your dealer.
Clean filter
Contact your dealer.
Refill removable tank.
Ventilate better.
and holding it down
key. The SAVE indicator
Tabla de contenido
loading

Tabla de contenido