5.3 Bluetooth Connection
When the EP725 is switched on, it will enter reconnection mode
and connect automatically to any previously known device. If no
previously connected devices are found, the EP725 will enter
pairing mode after 3 seconds.
To connect to a different device, first press and hold the + and -
buttons simultaneously for 5 seconds and then turn off the
EP725. This will disconnect the existing device. Then, switch
the EP725 back on to enter pairing mode.
In pairing mode, the status LED will flash blue rapidly.
- For mobile phones and tablets
1.Scan for available Bluetooth devices on your mobile phone or
tablet.
(Please consult the device's user manual for further instructions
if necessary.)
2.Select 'EP725' from the available devices and confirm the
connection. Some devices require a pin code. If this is the
case, please enter the code '0000'.
3.Once successfully connected, the status LED will flash blue.
- For computers
1.Enable the Bluetooth function on your computer.
2.Select 'Device and Printers' from the Control Panel and click
'Add a Device'.
3.Select 'EP725' from the available devices. The computer will
automatically install the driver. If a pin code is requested,
please enter the code '0000'.
4.Once successfully connected, the status LED will flash blue.
-5-
5.4 Noise Cancelling
Use the noise cancelling switch to enable / disable the noise
cancelling function. The status LED will light white while noise
cancelling is enabled.
5.5 Remote Control
Button
Operation
Press / Press and hold
Double Press
Press / Press and hold
Double Press
Press
Press and hold
5.6 Mobile Phone charging (OTG charging)
The power cable allows you to charge the EP725 from your
mobile phone.
To do so, first slide the micro USB port out from the end of the
cable by pressing down on the slot and pulling outwards as
shown in the diagram below.
To push the micro USB port back inside the cable, press the blue
catch and push the micro USB port inwards.
Function
Volume Up
Next track
Volume Down
Previous track
Play / Pause; Pick up / Hang up a call
Power on; Power off;
reject an incoming call
2
1
-6-