Steren CAU-265 Manual De Instrucciones página 23

Troubleshooting
The indicator LED is off
The indicator LED turn on, but the tip
don't heats up
The soldering cannot sticks into
the tip
The tip's temperature is very low
Specifi cations
Input: 120 V~ 60 Hz 60 W
Nominal consumption: 55 W/h
Stand-by power consumption: not applicable
.
• Verify that the power cord it is
connected or not is damaged.
• Check that the fuse is not broken, if
so, replace it.
• Verify that the soldering is
connected to the station.
• Verify that the soldering cable is not
damaged.
• Confi rm that the heating element is
not broken.
• Check that the temperature is
adequate.
• Verify that the tip is clean.
• Verify that the tip don't have oxide.
• Check the calibration of the
temperature.
23