EN
PRE-REPRODUCTION SETTINGS
REPRODUCTION and SETTINGS during the sound emission
To control the AP602 remotely (remote control), see the manual.
Select the source INT or EXT*
Select the noise type
White
Pink
Filtered pink
Set the volume
* For the EXT configuration see the manual
Start the reproduction
Start the reproduction in
(hold the key pressed for approx. 3 sec.)
the equipment reproduces sound for 20 seconds and
:
pauses for the next 20 seconds, consecutively until the
stop key is pressed.
Activate the equaliser
Frequency band selector
Level setting for the selected band
Stop the reproduction
The fan will stop and the status indicator will change
from
to
. After 3 seconds the noise reproduction
will stop and the indicator will change to
The fan will remain off for 30 seconds to facilitate the
measurement of decay curves in reverberation time
measurements.
intermittent operation mode
.
4