Craftsman 900 Serie Manual Del Usuario página 13

_CAUTION:Disconnect spark plug wire
before performing any maintenance to
prevent accidental starting of engine,
Prevent fires! Keep the engine free of
grass, leaves, spilled oil, or fuel. Remove
fuel from tank before tipping unit for main-
tenance. Clean muffler area of all grass,
dirt, and debris.
Do not touch hot muffler or cylinder fins as
contact may cause burns.
ENGINE
LUBRICATION
Use only high quality detergent oil rated
with API service classification SG-SL,
Select the oil's SAE viscosity grade ac-
cording to your expected temperature°
SAE VISCOSITY GRADES
IPm,!low.aol
'4 I I I
-20 0 20 40 60 80 !00" F
I I I I I 1 I l
-30 -20 -10 0 10 20 30 40_C
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
NOTE: Although multi-viscosity oils
(5W-30, 10W-30, etco) improve starting
in cold weather, these multi-viscosity oils
will result in increased oil consumption
when used above 32°F (O°C). Check your
engine oil level more frequently to avoid
possible engine damage from running low
on oil
Change the oil after every 50 hours of op-
eration or at least once a year if the tiller is
not used for 50 hours in one year,
Check the crankcase oil level before
starting the engine and after each five (5)
hours of continuous use. Add SAE 30
motor oil or equivalent, Tighten oil filler
plug securely each time you check the oil
level.
Determine temperature range expected
before oil change. All oil must meet API
service classification SG-SLo
• Be sure tiller is on level surface.
• Oil will drain more freely when warm.
• Catch oil in a suitable container,
1, Remove drain plug.
2, Tip tiller forward to drain oil,
3. After oil has drained completely,
replace oil drain plug and tighten se-
curely.
4. Remove oil filler plug, Be careful not
to allow dirt to enter the engine.
5. Refill engine with oil. See "FILL
ENGINE WITH OIL" in the Operation
section of this manual,
Oil
Drain
Plug
Oil Level
Oil Filler Plug
AIR CLEANER
Service air cleaner cartridge every
twenty4ive hours, more often if engine is
used in very dusty conditions,
1. Loosen air cleaner screw(s).
2. Remove air cleaner cover.
3, Carefully remove air cleaner cartridge.
Be careful, Do not allow dirt or debris
to fall into carburetor,
4o Clean by tapping gently on a flat sur-
face,
NOTE: If very dirty, or damaged, replace
cartridge,
5. Clean and replace cover. Tighten
screw(s) securely.
,_CAUTION: Petroleum solvents, such
as kerosene, are not to be used to clean
cartridge, They may cause deterioration
of the cartridge° Do not oil cartridge. Do
not use pressurized air to clean or dry
cartridge
Air Cleaner
Cartridge
Pre-Cleaner
Cover
Air aner
Screws
13