TROUBLESHOOTING
CAUSE SOLUTION
PROBLEM
◾
The battery pack is not attached to the
line trimmer.
◾
No electrical contact between the
machine and battery.
◾
The battery pack is depleted.
Fail to start
◾
The lock-off lever and trigger switch are
not depressed simulta-neously.
◾
Heavy cutting line is used.
◾
The motor is overloaded.
The machine stops
◾
The battery pack or machine is too hot.
working while cutting
◾
The battery pack is disconnected from
the machine.
◾
The battery pack is depleted.
◾
The motor shaft or trimmer head is
wound with grass.
◾
There is no enough line in the trimmer
head.
◾
The cutting line can't
The trimmer head is dirty.
be released (only using
with trimmer head).
◾
Line is tangled in the trimmer head.
◾
The line is too short.
◾
Grass wraps around
Cutting tall grass at ground level.
trimmer head and
motor housing
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER/BRUSH CUTTER — BCX4500
SOLUTION
◾
Attach the battery pack to the line
trimmer.
◾
Reinsert the battery pack.
◾
Charge the battery pack.
◾
Press down the lock-off lever and hold
it, then depress the trigger to turn on
the machine.
◾
Use recommended nylon cut-ting line
with diameter no greater than 2.7 mm.
◾
The machine will recover when the load
is removed. For con-tinuous working,
reduce the load of the machine.
◾
Allow the battery pack or machine to
cool until the tem-perature drops below
67°C.
◾
Re-install the battery to the machine.
◾
Charge the battery pack.
◾
Stop the trimmer, remove the battery
and remove the grass from the motor
shaft and trimmer head.
◾
Remove the battery and re-place the
cutting line; follow the section "LINE
REPLACE-MENT" in this manual.
◾
Remove the battery and clean the lower
cover assembly, spool and upper cover.
◾
Remove the battery, remove the line
from the spool and re-wind; follow the
section "LINE REPLACEMENT" in this
manual.
◾
Remove the battery and pull the line
while alternately pressing down on and
releasing the trimmer head.
◾
Cut out the weeds into several sections
from top to ground level.
EN
15