Idiomas disponibles
Idiomas disponibles
DH-40
| Shower aid
DH-40 L
5. Assembly and customisation
You can adjust your shower aid yourself with a little manual
dexterity. If you have any questions, please contact your
specialist dealer.
5.1. Assembly
4.
The shower aid is supplied in individual parts. Assembly is very simple
and can be carried out in accordance according to the following
instructions. All you need is a Phillips screwdriver. If you have any
questions about fitting, please contact the medical supply retailer
who supplied you with the product
Caution: risk of jamming! When assembling
5.
there is a risk of entrapment.
5.2. Mounting the legs
•
Place the seat surface with the underside facing upwards on a
stable ground and first screw the legs with the labelling (1) to the
two outer holes (Fig. 4)
6.
•
Then screw the legs with the labelling (2) onto the seat and tighten
all screws firmly (Fig. 5).
Attention! Observe the correct sequence. Only
This ensures correct fastening.
36
4.2. Mounting the handles
•
Lay the shower aid on its side and insert the handles into the
openings provided (Fig. 6).
•
Tighten the plastic screws underneath the seat by hand (Fig. 7).
5.3. Mounting the backrest
•
Stand from behind the safely positioned shower aid.
•
Take the backrest and press it into the recess. Pay attention to the
alignment. The backrest only fits into the recess in one direction
(Fig. 8).
Caution! The lower part of the backrest must
protrude approx. 5 mm from the underside of
the seat.
5.4. Adjusting the seat height
•
Place the shower aid on its side to take the strain off your legs.
•
Press in the push button and move the outer tube.
•
Slide the outer tube to the desired seat height and engage the push
button in the corresponding hole (Fig. 9).
•
Repeat the adjustment for the other three legs, ensuring the same
height setting.
Bischoff & Bischoff GmbH | 05-12-2023 - Revision: 2
DH-40
Shower aid |
DH-40 L
7.
8.
9.
37
