Product appearance is for reference only
and may differ from the actual product.
Symbols and Marks
i. Not necessarily included accessory.
ii. Variable accessory amount.
iii. Skip this step if not required.
Other situations
Purchase separately
Disposal
Turn to page A and continue.
Interface and Parts Description (Page 2 – A)
Note:
The interface or cable varies with the models.
Please refer to the product datasheet for details.
1. Microphone
2. Supplement Light
3. Battery Compartment
4. Lens
5. Photoresistance
6. Antenna
7. Indicator
8. PIR Detector
9. Case
10. DEBUG/RESET/SETUP Button
11. MicroSD Card Slot
12. Micro SIM Card Slot
13. Dialing Button
14. Strap
15. Battery Charging Cable
16. Battery Power Adapter
17. Chargeable Battery
18. Battery Charging Interface (Type-C)
19. Battery Indicator
20. Power Input Interface
21. Solar Panel
22. Extension Cable
23. Debug Network Interface
24. Debug Power Interface
25. Debug Serial Port
Indicator Description
Camera Body Indicator:
Solid red: Power up the camera.
Fast-flashing red:
1) MicroSD card is not inserted or microSD
English
Slow-flashing red: The camera is not activated.
Fast-flashing blue: Connecting to network failed.
Slow-flashing blue: The camera works normally.
Battery Indicator:
No light: Battery exception.
Solid red: The battery is charging and the power
Solid red and flashing green: The battery is
Solid green: The battery is fully charged.
Install the Memory Card or Micro SIM Card (Page 4
– B)
10: DEBUG/RESET/SETUP Button
11: MicroSD Card Slot
12: Micro SIM Card Slot
Install the Battery and Activate and Access Network
Camera (Page 7 – C)
(Optional) Install the dry cells to the lower row
Install the chargeable battery or dry cell
Activate and access the camera by connecting the
Close the top cover and press the snap. (C4).
Install the Solar Panel (Page 10– D)
Note:
panel.
Install the Camera (Page 11 – E)
13
card exception occurs. You can try to
format the card.
Caution:
Back up the data first before formatting the
microSD card.
2) Other exceptions, such as temperature
sensor exception.
It might be caused by the following reasons:
SIM card is not inserted, SIM card does not
connect to network, dialing failed, the camera
is dialing, or the signal strength is weak.
Note:
This applies to the camera with antennas.
is within 80%.
charging and the power is 80% to 100%.
1) Debug: When the camera is running, press
this button to switch standby mode or
performance mode.
2) Reset the camera: Press reset button for
about 10 s when the camera is powering on
or rebooting to restore the default settings,
including the user name, password, IP
address, port No., etc.
first. Prepare 10 AA size dry cells first. (C1)
compartment. After installation, switch the
dialing button to ON to power on the camera
with battery. (C2)
cable to the computer. Scan the QR code for details.
(C3)
Note:
The cable and the serial port are only for
debugging. Refer to datasheet for details
about the interface requirement.
The debug power interface is used for
debugging only when the device is not on
battery power.
This applies to the camera supplied with solar
