Idiomas disponibles
Idiomas disponibles
wall mounting holes for the respective brackets (1+2+3). Insert the bushings
•
(4) and tighten the clamps with screws (5/6).
•
Install the suspension rail (1) onto the hood body, as well as the mounting rail with the clamp (2) on
the upper edge, parallel to the rail (1). Determine the length of the duct cover extension in advance!
•
Before hanging, insert the connecting piece with the non-return valves into the exhaust pipe from
above. Check that the connector's mounting hooks snap into place.
For extraction mode:
• You must connect the supplied flexible extraction tube with an inside diameter of Ø 150 mm (Fig.
and connected to the outside through the extraction outlet.
• Fix the hood to the suspension rail (1) . Make sure it is secure and level horizontally.
• Remove the protective plastic from the telescopic conduit .
• Fix the outer (lower) duct with the mounting rail, without the clamp (3). The gutter is
attached to the holes provided from the inside of the duct. Screw in two screws (7)
from the back.
• Place the outer duct with the fixed rail (3) over the hood. Fasten the rail (3) to the wall,
parallel to the other rails (1+2).
• Slide the inner (top) duct along the slide fitting, into the outer duct
(bottom). Check that the inner duct lines up with the top ventilation holes. Determine
the length of the duct cover extension by pulling the inner duct up or sliding it back
into the outer duct.
• For extraction mode, position the extraction hose correctly.
• Pull up the inner duct cover and fix the duct unit on the side of the previously mounted
rail (2) by tightening the screws (6+7).
Activated carbon filter installation for recirculation mode
• Remove the aluminum grease filter.
• Place the charcoal filter over the air inlet of the extraction duct. Check that the extraction duct mounting
studs fit into the charcoal filter mounting slots. Rotate the corresponding filter clockwise until it clicks into
place.
• Reinstall the aluminum grease filter.
p
31
a
