Idiomas disponibles
Idiomas disponibles
Your new tractor
has been assembled
at the factory
with the exception
of those
parts left
unassembled
for shipping
purposes.
To ensure
safe and proper
operation
of your tractor
all parts and hardware
you assemble
must be tightened
securely.
Use the correct
tools
as necessary
to insure
proper
tightness.
TOOLS
REQUIRED
FOR
ASSEMBLY
A socket wrench
set will make assembly
easier.
Standard
wrench
sizes you need
are listed below.
(1) 3/4" wrench
(1)
Pliers
(1)
1/2" wrench
(1)
Utility knife
(1) Tire pressure
gauge
When
right or left hand is mentioned
in
this manual,
it means,
from your point of
view, when you are in the operating
posi-
tion (seated
behind
the steering
wheel).
TO
REMOVE
TRACTOR
FROM
CARTON
UNPACK
CARTON
1.
Remove
all accessible
loose parts and
parts boxes from carton.
2.
Cut along dotted
lines on all four pan-
els of carton.
Remove
end panels
and
lay side panels
flat.
3.
Check
for any additional
loose parts or
cartons
and remove.
BEFORE
REMOVING
TRACTOR
FROM
SKID
ATTACH STEERING WHEEL
ASSEMBLE
EXTENSION
SHAFT
AND
BOOT
1.
Slide extension
shaft onto lower steer-
ing shaft.
2.
Place tabs of steering
boot over tab
slots in dash and push down to secure.
INSTALL
STEERING
WHEEL
3.
Position
front wheels
of the tractor
so
they are pointing
straight
forward.
4.
Remove
steering
wheel
adapter
from
steering
wheel
and slide adapter
onto
steering
shaft extension.
5.
Position
steering
wheel
so cross bars
are horizontal
(left to right) and slide
inside
boot and onto adapter.
6.
Assemble
large flat washer,
5/16 lock
washer,
5/16 hex bolt and tighten
se-
curely.
7.
Snap steering
wheel
insert
into center
of steering
wheel.
8.
Remove
protective
materials
from trac-
tor hood and grill.
Steering
Wheel
Insert
5/16 Hex Bolt
Slots
IMPORTANT:
Check
for and remove
any
staples
in skid that may puncture
tires
where
tractor
is to roll off skid.
INSTALL
SEAT
Adjust
seat before
tightening
adjustment
bolt.
1. Remove
adjustment
bolt, lock washer
and flat washer
securing
seat to
cardboard
packing
and set aside
for
assembly
of seat to tractor.
2.
Pivot seat upward
and remove
from
the cardboard
packing.
Remove
the
cardboard
packing
and discard.
3.
Place
seat on seat pan so head of
shoulder
bolt is positioned
over large
slotted
hole in pan.
4.
Push
down on seat to engage
shoulder
bolt in slot and pull seat towards
rear of
tractor.
5.
Pivot seat and pan forward
and as-
semble
adjustment
bolt, Iockwasher
and flat washer
loosely.
Do not tighten.
