Idiomas disponibles
Idiomas disponibles
TRANSMISSION
REMOVAL/
REPLACEMENT
Should
your transmission
require
removal
for service
or replacement,
it should
be
purged
after reinstallation
and before
op-
erating
the tractor.
See "PURGE
TRANS-
MISSION"
in the Operation
section
of this
manual.
TO ADJUST
STEERING
WHEEL
ALIGN-
MENT
If steering
wheel
crossbars
are not
horizontal
(left to right) when
wheels
are
positioned
straight
forward,
remove
steer-
ing wheel
and reassemble
with crossbars
horizontal.
Tighten
securely.
FRONT
WHEEL
TOE-IN/CAMBER
The front wheel
toe-in
and camber
are not
adjustable
on your tractor.
If damage
has
occurred
to affect the front wheel toe-in
or camber,
contact
our authorized
service
center/department.
TO REMOVE
WHEEL
FOR REPAIRS
1.
Block up axle securely.
2.
Remove
axle cover,
retaining
ring and
washers
to allow wheel
removal
(rear
wheels
have a square
key - Do not
lose).
3.
Repair
tire and reassemble.
NOTE:
On rear wheels
only:
align grooves
in rear wheel
hub and axle.
Insert square
key.
4.
Replace
washers
and snap
retaining
ring securely
in axle groove.
5.
Replace
axle cover.
NOTE:
To seal tire punctures
and prevent
flat tires due to slow leaks,
purchase
and
use tire sealant
from an authorized
service
center/department.
Tire sealant
also pre-
vents
tire dry rot and corrosion.
Washers
Retaining
Ring
Axle
Cover
Square
Key
(Rear Wheel Only)
I
TO START
ENGINE
WITH A WEAK
BAT-
TERY
,_kWARNING:
Lead-acid
batteries
generate
explosive
gases.
Keep sparks,
flame and smoking
materials
away from
batteries.
Always
wear eye protection
when around
batteries.
If your battery
is too weak to start the
engine,
it should
be recharged.
(See "BAT-
TERY"
in the MAINTENANCE
section
of
this manual).
If "jumper
cables"
are used for emergency
starting,
follow this procedure:
IMPORTANT:
Your tractor
is equipped
with a 12 volt system.
The other vehicle
must also be a 12 volt system.
Do not use
your tractor
battery
to start other vehicles.
TO ATTACH
JUMPER
CABLES
-
1. Connect
one end of the RED cable
to the POSITIVE
(+) terminal
of each
battery(A-B),
taking
care not to short
against
tractor
chassis.
2.
Connect
one end of the BLACK
cable
to the NEGATIVE
(-) terminal
(C) of
fully charged
battery.
3.
Connect
the other end of the BLACK
cable
(D) to good chassis
ground,
away from fuel tank and battery.
TO REMOVE
CABLES,
REVERSE
ORDER
-
1.
BLACK
cable first from chassis
and
then from the fully charged
battery.
2.
RED cable
last from both batteries.
DD
02614
Weak or Dead
Fully Charged
Battery
Battery
29
