Idiomas disponibles
Idiomas disponibles
7.2 Replacing the line spool
Danger! Remove the battery!
1. Fig. 19 Press the line spool housing together
at the points marked M and remove the spool
cover.
2. Remove the empty string holder.
3. Fig. 20 Thread the end of the line on the new
line spool through the eyelet (F) in the spool
cover and allow approx. 18 cm of line to pro-
ject.
4. Press the spool cover back into the line spool
housing.
7.3 Replacing the cutting line
Danger! Remove the battery!
1. Fig. 19 Press the line spool housing together
at the points marked M and remove the spool
cover.
2. Remove the empty string holder.
3. Remove any remaining cutting line if there is
any.
4. Fig. 21 Insert the new string into the string hol-
der (D) inside the spool.
5. While keeping the string under tension, wind it
up in the direction indicated by the arrow.
6. Fig. 22 Hook the line, approx. 20 cm before
the end of the line, into one of the line holders
on the edge of the spool.
7. Fig. 20 Thread the end of the line on the new
line spool through the eyelet (F) in the spool
cover.
8. Pull the line sharply to release it from the line
holder.
9. Press the spool cover back into the line spool
housing.
When you start the equipment again the line will
be cut to the perfect length automatically.
Caution! Bits of the nylon line could cause
injury when fl ung out.
7.4 Maintenance
There are no other parts inside the equipment
which require maintenance.
7.5 Ordering spare parts
Please provide the following information on all
orders for spare parts:
•
Model/type of the equipment
•
Article number of the equipment
•
ID number of the equipment
•
Spare part number of the required spare part
For our latest prices and information please go to
www.Einhell-Service.com
Anl_GE_CT_18_33_Li_E_SPK13.indb 24
Anl_GE_CT_18_33_Li_E_SPK13.indb 24
GB
Spare line spool Art. No.: 34.050.96
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Defective components must be dispo-
sed of as special waste. Ask your dealer or your
local council.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30 °C.
Store the electric tool in its original packaging.
10. Transport
•
Always carry the tool with one hand on the
handle and the other on the additional handle.
Do not carry the tool by the motor housing.
•
Secure the tool against slipping if transporting
it by car.
•
If possible, use the original packaging for
transportation.
11. Faults
The equipment does not work:
Check that the battery is charged and whether
the charging unit is working. If the equipment will
not work in spite of the voltage supply being OK,
please send it to the customer service address
below.
- 24 -
01.06.2023 10:19:23
01.06.2023 10:19:23
