Waeco PerfectView Instrucciones De Montaje Y Uso página 44

_RV-33.book Seite 44 Donnerstag, 30. November 2006 1:41 13
Fitting the camera
Creating a through-hole for the camera connection cable (fig. k,
page 9)
Note
I
If possible, use available openings, such as ventilation grilles, to
feed the connection cables through. If there are no existing open-
ings, you must drill a hole with a 13 mm diameter. Check
beforehand that there is sufficient space for the drill head to come
out on the other side.
➤ Drill a hole of Ø 13 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place cable sleeves in all sharp-edged ducts.
Attaching the camera and camera guard
Caution!
a
Never mount the camera without the additional camera guard. To
mount the camera guard, only use the M3 x 8 mm screws provid-
ed. Longer screws will damage the camera.
➤ Push the camera guard (fig. 8 4, page 5) over the camera in such a way
that:
– The fixing hole of the camera guard (fig. l, page 9) is over the 3-mm
thread of the camera.
– The two other fixing holes (fig. m, page 9) are over the 4-mm threads
of the camera.
➤ Secure the camera guard with the two M3 x 6 mm screws in the hole
(fig. l, page 9).
➤ Push the camera into the bracket (fig. m, page 9).
Caution!
a
Only use the screws supplied to mount the camera in the camera
holder. Longer screws will damage the camera.
➤ Secure the camera loosely with the four M4 x 10 mm screws in the two
other fixing holes (fig. m, page 9).
The camera is now centred.
44
PerfectView