Idiomas disponibles
Idiomas disponibles
2. MOUNTING THE LIGHT FIXTURE.
•
Turn OFF the main power supply before installation, to avoid
electric shock live work is not allowed during installation.
•
Use the Allen key included to withdraw the mounting screws on
the side of the light fixture and take out the mounting bracket.
The screws and mounting bracket should be put away, please do
not discard. Wait for the next installation and use.
•
Please fix the mounting bracket on the junction box reserved on
the wall of your house. The screws must be locked tightly to avoid
loosening and instability when installing the light fixture later.
3. WIRING THE LIGHT FIXTURE.
Wire the light fixture using the included wire connectors.
NOTE:
All wiring must be run in accordance with the National
Electrical Code through conduit or another acceptable means. Contact
a qualified electrician if there is any question as to the suitability of the
system.
•
Connect black to black.
•
Connect white to white.
•
Connect green to the ground wire from the house.
After the wires of the light fixture are connected, install the light fixture
on the mounting bracket, align the side hole of the mounting bracket
with the side hole of the light fixture, and then insert the screws and
tighten.
4. CAULKING AROUND THE LIGHT FIXTURE.
CAUTION:
Failure to completely caulk around the light fixture's
mounting plate could result in water seepage into the light
fixture and/or junction box.
•
Caulk around the light fixture and mounting surface with silicone
sealant (not included).
INSTALLATION:
