Idiomas disponibles
Idiomas disponibles
FRONT
WHEEL
TOE-IN/CAMBER
Your new tractor
front wheel toe-in and cam-
ber is set at the factory
and is normal.
The
front wheel toe-in and cam ber are not adjust-
able.
If damage
has occurred
to affect the
factory
set front wheel toe-in or camber,
con-
tact a Sears or other qualified
service
center.
TO REMOVE
WHEEL
FOR REPAIRS
1. Block up axle securely.
2. Remove
axle cover, retaining
ring and
washers
to allow wheel removal
(rear
wheels have a square key - Do not lose).
3. Repair tire and reassemble.
Washers
Retaining
Ring
Axle Cover
1
'_-_Square
Key (Rear
Wheel Only)
NOTE: On rear wheels only: align grooves in
rear wheel hub and axle. Insert square key.
4. Replace washers and snap retaining ring
securely in axle groove.
5. Replace axle cover.
NOTE: To seal tire punctures
and prevent
flat tires due to slow leaks, purchase
and
use tire sealant from Sears. Tire sealant also
prevents tire dry rot and corrosion.
TO
START
ENGINE
WITH
A
WEAK
BATTERY
_,WARNING:
Lead-acid
batteries
gener-
ate explosive
gases.
Keep
sparks,
flame
and smoking
materials
away from batteries.
Always
wear
eye protection
when
around
batteries.
Ifyour
battery is too weak to start the engine,
it
should
be recharged.
(See "BATTERY"
in the
MAINTENANCE
section
of this manual).
If "jumper
cables"
are used for emergency
starting,
follow
this procedure:
IMPORTANT:
Your tractor
is equipped
with
a 12 volt system.
The other vehicle
must also
be a 12 volt system.
Do not use your tractor
battery
to start other vehicles.
TO ATTACH
JUMPER
CABLES
-
1.
Connect
one endofthe
RED cable to the
POSITIVE
(+) terminal
of each battery(A-
B), taking care notto short against tractor
chassis.
2.
Connect
one end of the BLACK
cable
to the NEGATIVE
(-)terminal
(C) of fully
charged
battery.
3.
Connect
the
other
end
of the
BLACK
cable
(D) to good chassis
ground,
away
from fuel tank and battery.
TO REMOVE
CABLES,
REVERSE
ORDER-
1.
BLACK
cable first from chassis
and then
from the fully charged
battery.
2.
RED cable
last from
both batteries.
WEAK OR DEAD
FULLY CHARGED
BATTERY
BATTERY
REPLACING
BATTERY
n_a sWARNING:
Do not short battery
termi-
by allowing
a wrench
or any other object
to contact
both terminals
at the same time.
Before
connecting
battery,
remove
metal
bracelets,
wristwatch
bands,
rings,
etc.
Positive
terminal
must be connected
first to
prevent
sparking
from accidental
grounding.
1.
Lift seat pan to raised
position
and open
battery
box door.
2.
Disconnect
BLACK
battery
cable
first
then
RED
battery
cable
and
carefully
remove
battery
from tractor.
3.
Install new batterywithterminals
in same
position
as old battery.
4.
First connect
RED battery
cable to posi-
tive (+) terminal
with hex bolt and keps
nut as shown.
Tighten
securely.
5.
Connect
BLACK
grounding
cable
to
negative
(-) terminal
with remaining
hex
bolt and keps nut. Tighten
securely.
6.
Close
battery
box door.
26
