Idiomas disponibles
Idiomas disponibles
Once you have checked the appliance, deactivate
and activate the appliance. If the problem occurs
again, contact an Authorised Service Centre.
THE WASHING AND DRYING RESULTS ARE NOT SATISFACTORY
Problem
There are whitish streaks or blu-
ish layers on glasses and dishes.
There are stains and dry water
drops on glasses and dishes.
The dishes are wet.
Refer to "Hints and tips" for other
possible causes.
ACTIVATING RINSE AID WITH OPTION MULTI TAB ACTIVATED
1. Make sure that the appliance is in Programme selection mode.
2. Turn the programme knob until the programme marker is aligned with
3. Press and hold at the same time Multi Tab and Delay until the indicators
flash .
4. Press Delay. The indicators
the current setting of the rinse aid dispenser.
•
= rinse aid dispenser deactivated.
•
= rinse aid dispenser activated.
5. Press Delay again to change the setting.
6. Press on/off button to deactivate the appliance and to confirm the setting.
14
For alarm codes not described in the table, contact
an Authorised Service Centre.
•
The release quantity of rinse aid is too much. Adjust the rinse
aid selector to a lower position.
•
The quantity of detergent is too much.
•
The released quantity of rinse aid is not sufficient. Adjust the
rinse aid selector to a higher position.
•
The quality of the rinse aid can be the cause.
•
The programme does not have a drying phase or has a drying
phase with low temperature.
•
The rinse aid dispenser is empty.
•
The quality of the rinse aid can be the cause.
•
The quality of the multi-tablets can be the cause. Try a differ-
ent brand or activate the rinse aid dispenser and use rinse
aid and multi-tablets together.
and
go off. The indicator
Possible solution
.
,
continues to flash. The display shows
and
start to
