Idiomas disponibles
Idiomas disponibles
ADJUST
AUGER CONTROLCABLE
The auger control cable was adjusted
at the factory. If the auger will not en-
gage or disengage correctly, adjust the
auger control cable as follows:
1. Loosen the nut that holds the cable
tension
spring (See Figure 9).
2. Slide the cable tension
spring to-
ward the rear of the unit until all
cable slack is removed.
NOTE: The auger control cable is
properly adjusted when the free
cable slack is removed and there is
no tension on the idler arm.
3. Tighten the nut that holds the cable
tension
spring.
If belt stretch has occured, move the
end the auger control cable to the out-
side hole as follows:
1. Loosen the nut that holds the cable
tension
spring (See Figure 9).
2. Move the cable tension
spring to-
ward the front of the unit to achieve
maximum cable slack.
3. Remove the upper end of the auger
control cable from the auger drive
lever.
4. Install the auger control cable in
the hole shown in Figure 10.
5. Slide the cable tension
spring to-
ward the rear of the unit until all
cable slack is removed.
NOTE: The auger control cable is
properly adjusted when the free
cable slack is removed and there is
no tension on the idler arm.
6. Tighten the nut that holds the cable
tension
spring.
I
Spring
Auger
Drive Lever
Figure 9
Handle
\
Cable
Figure 10
F-031049C
16
