Idiomas disponibles
Idiomas disponibles
A. Cold water inlet valve
B. Hot water inlet valve
2. Attach hose to bottom inlet valve opening first.
3. Attach second hose to top inlet. Tighten couplings
by hand; then use pliers to make an additional
two-thirds turn.
NOTE: Inlet valve threads are plastic. Do not strip
or cross-thread.
5.
Measure and mark a point approximately
40.6 cm (16")
from the plug end of the shipping strap. Cut shipping strap at
this point.
6.
Check that hose is not twisted or kinked and is
securely
in place.
Put "hook" end of drain hose into standpipe.
Tightly wrap the shipping strap around the
standpipe. Push plug into the nearest hole in
the shipping strap.
Connect
the inlet hoses
to the water
taps
1. Before attaching water inlet hoses to the water taps, run
water through both taps into a bucket. This wilt get rid of
particles in water lines that might clog hoses. Mark which is
the hot water tap.
2. Install a black plastic tap adapter on each inlet hose.
3. Attach bottom hose (inlet marked "H') to hot water taps.
Tighten coupling to taps by hand.
4. Attach top hose (inlet marked "C") to cold water taps. Tighten
coupling to taps by hand.
5. Use pliers to make an additional two-thirds turn to each
coupling.
Install the front
leveling
feet
1.
2.
Stack two corner posts on top of each other. Tilt washer
backward and insert corner posts 7.6 cm (3") in from one side
of washer as shown. Repeat with other corner posts on other
side of washer.
Use the leveling legs and nuts from parts package. Screw nut
down to within 1.3 cm (1/2")from base.
A. 1.3cm (V2")
B. Base
C. Nut
3. Insert legs into correct holes at
each front corner of washer
until nuts touch washer. Do not
tighten nuts until the washer
is leveled.
4. Tilt washer backward and
remove corner posts. Gently
lower washer to floor.
5. Move washer to its permanent
location. Remove cardboard or
hardboard from under washer.
/
7
