Idiomas disponibles
Idiomas disponibles
INSTRUGnON MANUAL
Industrial Triplex Pumps
INDUSTRIAL TRIPLEX PUMPS
5.
Refill pump using SIMPSQNCII
Premium Pump Crankcase Oil. If
this oil is not available, an SAE
15W-40 oil may be used.
6.
Replace pump oil fill plug and
tighten securely.
CLEAN THE WATER INLET FILTER
This screen filter should be checked
periodically and cleaned
if
necessary.
1.
Remove filter by grasping end
and removing it from water inlet of
pump.
2.
Clean filter by flushing it with water
on both sides.
3.
Re-insert filter into water inlet of
pump.
NOTE:
Convex side faces
out.
NOTE: Do not operate the pressure
washer without filter properly installed.
STORAGE
The manufacturer recommends using
SIMPSON• I POWERWASHERI Pump
Guard (part #80130) or equivalent
when
storing the unit for more
than 30 days and/or when freezing
temperatures are expected. SIMPSON•
I POWERWASHERI Pump Guard is
environmentally friendly.
NOTE: Using pump guard helps provide
proper lubrication to the internal seals
of the pump regardless of temperature
or environment.
NOTICE:
Risk of property
damage.
Use
only SIMPSOf'./8 I
POWERWASHE~
Pump Guard or equivalent. Other
products could be corrosive and/or
contain alcohol which may cause pump
damage.
1.
Turn off pressure washer and
disconnect hoses from pump.
2.
Unscrew bottle valve from Pump
Guard bottle and remove seal.
3.
Screw bottle valve back onto
bottle.
4.
Attach bottle to water inlet of
pump.
5.
Squeeze bottle to inject contents
into pump.
6.
With
ignition
switch
off,
simultaneously pull starter rope
and squeeze bottle. Repeat until
protector fluid exits pump outlet.
NOTE:
This step may require two
people.
LIMilED WARRANTY
The manufacturer of this product agrees
to repair or replace designated parts
that prove defective within the warranty
period listed below at the manufacturer's
sole discretion. Specific limitations/
extensions and exclusions apply.
This warranty
covers
defects in material
and workmanship and not parts failure
due to normal wear, depreciation,
abuse, accidental damage, negligence,
improper use, maintenance, water quality
or storage. To make a claim under the
terms of the warranty, all parts said to be
defective must be retained and available
for return upon request to a designated
Warranty Service Center for warranty
inspection. The judgments and decisions
of the manufacturer concerning the
validity of warranty claims
are
final.
These warranties pass through to the
end user and are non-transferable.
As
a
factory authorized and trained Warranty
Service Center, the factory will honor the
terms of all component warranties and
satisfy claims of the appropriate warranty
provisions.
Normal wear items include, but are not
limited to, valves and seals, which are not
covered by this
warranty.
This
warranty
replaces
all
other
warranties, express or implied, including
without limitation any warranties of
merchantability or fitness for a particular
purpose and all such warranties are
hereby disclaimed and excluded by
the manufacturer. The manufacturer's
warranty obligation is limited to repair
4- ENG
140*213MM
