Idiomas disponibles
Idiomas disponibles
Pottery Barn – Pottery Barn Teen – Pottery Barn Kids – Williams Sonoma Home – West Elm – Rejuvenation – Mark and Graham
18-Mar-2022
Clean the sensor lens with soft cloth every 1 or 2 months to dust the sensor and prevent less sensitivity.
Detection distance
The detection distance was set at the maximum at the factory.By turning the knob counterclockwise, the detection
distance can be decreased to 5' as the minimum.
The detection range can reach the coverage of approximately 120 degrees.
Shut-off Delay time
The light will stay ON as long as motion is detected. When people leave, the light will turn OFF after the delay time
has elapsed. The time is 5 sec at the minimum; By turning the knob clockwise, it will increase the time up to 3 min.
as the maximum.
Trouble Shooting
If the light does not come ON at all
1. Make sure the wall switch and the circuit breaker is ON and the wiring is correct.
2. Adjust the Detection distance knob clockwise to increase the detection distance.
3. When in AUTO Mode, cover the sensor with your palm to verify the light level is not too high.
If the light stays on continuously
1.
Make sure the light is not in Manual Mode. Reset the fixture by turning the power off for one minute then on again.
2.
Make sure there is no motion existing in the detection area.
3.
Adjust the Time knob counterclockwise to reduce the Shut-Off delay time.
If the light blinks
1. Make sure the light is not mounted near any heat source.
2. Reduce the detection distance to avoid undesired triggering by passing cars or reflecting objects.
Williams-Sonoma Inc.
Assembly Instructions
Instructions d'assemblage
Instrucciones de Ensamblaje
16/20
US/CA-A
