Idiomas disponibles
Idiomas disponibles
prevention regulations.
• Make sure that the area of application has
sufficient water drainage. Close feed valve in
case of prolonged shut-down times.
• Spilling resin is a slipping hazard.
• Resin can cause skin irritation. Avoid skin
contact.
• Can cause eye irritation. Avoid eye contact.
Wear safety goggles. In case of eye contact,
immediately flush eyes thoroughly with clean
water. Consult doctor if symptoms persist.
Operational safety:
CAUTION: The tank may only be filled with a
maximum of 5 litres liquid.
• Inspect the Water Softener visually before
each use.
• Never leave your Water Softener unattended
and do not store for long periods when long
periods when full and pressurised.
• Keep the unit out of the reach of children. You
are responsible for the safety of others.
• Keep your Water Softener away from heat
sources and hot environments.
• Screw on the lid tightly by hand (do not use
tools) and ensure that the O-ring is positioned
correctly.
• Using water pressure must not be higher than
8bar / 0.8MPa to avoid the damage of product.
Storage safety:
• Before storing, drain the water softer from
water and close the lid and valves.
• Store away from frost.
• Carry the Water Softener by the handle. Make
sure the lid is secured tightly before carrying.
• Make sure that the product is protected from
direct sunlight. The product may heat up.
2. MACHINE INFORMATION
Intended use
This device may cause danger if it is improperly
installed, not regularly maintained or not used as
intended. Use this device only for water treatment
to reach an optimal water quality for glass, car,
façade and solar panel cleaning. Any other use,
especially water treatment for food production
(e.g. beverages) is considered as non-intended
and not allowed.
When operating with a tap waterIine, it must be
assured that the connected water tap is equipped
with a rebound valve to prevent water flowing
back into drink water line!
When operating with water other than from
drinking water system, e.g. from a well, a water
analysis must be performed prior to application
to determine if the water is suitable. Excess
impurities in the water may have an adverse effect
on system performance and cleaning result.
Operating temperatures, pressures and
connection
The system must be protected against frost. The
temperatures in the service room must be at least
4°C. The water temperature may not exceed
30°C, and maximum operating pressure is 8 bar.
TECHNICAL SPECIFICATIONS
Model No.
Container capacity
Weight (incl. resin)
Dimension (LxWxH)
Max. inlet water pressure
Max. water temp.
Min. water temp.
Inlet hose length
Flush hose length
Flowmeter model No.
Flowmeter battery
Resin type
Amount resin included
Max operating temperature
Particle size range
PH range
Service flow rate
Regenerant
Lifespan resin
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-4.
1. Tank
2. Lid
3. Inlet valve
4. Outlet valve
5. Flowmeter
6. Inlet hose
7. Flush hose
8. Hose connector
WSA1020
5 Liter
5 kg
255x195x345mm
8 bar / 0.8MPA
30 °C
5 °C
100cm
150cm
WSA1022
Li-Mn CR2032
Lanlang TC008FGF
4 Liter
120 °C
0.2-0.56mm
0-14
5-50 BV/h
10-15% NaCl
>10 years
5
