Idiomas disponibles
Idiomas disponibles
ENGLISH
cm between the top part of the appliance
and the ceiling. A wrong positioning could
lead to increasing the noise level.
It is possible to install certain appliances
without a minimum distance. Check with
an authorized dealer or kitchen designer.
Change of the door opening side.
See picture 02 on page 4
• Remove the two screws that fix the
upper hinge; Remove the top hinge,
disassemble the door and set it aside
carefully. (Fig. 1)
• Remove the three screws that fix the
hinge on the lower right side of the
appliance; remove the top hinge and the
adjustable foot under the lower hinge
under the right side of the cabinet. (Fig.
2)
• At the same time, use a wrench to
remove the screws that fix the hinge
shaft, remove the hinge shaft down
• Then remove the adjustable foot on the
lower left side below the left side of the
cabinet. (Fig. 2)
• Screw the adjustable foot that is on the
left side previously to the corresponding
position on the right side under the
cabinet; turn the hinge down 180
degrees and fix the hinge shaft down
into the hole in the lower hinge, then
turn the hinges and screws hard. (Fig.
3 and 4 )
• Do the same for the adjustable foot that
is on the right side previously to the
corresponding position on the left side
under the cabinet; Then I turn the three
screws that fix the lower hinge firmly.
(Fig. 3 andy 4 )
• Place the door in the correct position
and make sure that the hinge axis down
and the hole in the shaft on the lower
left side of the machine are properly
fixed and connect correctly; turn all
the screws with force; then, fix the top
flange with screws. Finally, the process
of changing the direction of the door is
done. (Fig. 5 and 6)
36
USING THE APPLIANCE
Control panel.
See picture 02 on page 4
• To control the temperature, please use
the knob inside of this appliance. You
can regulate the temperature to any of
the following positions:
• In the 0 position, the appliance does not
work (the cooling system is switched
off), but the power supply is not
interrupted.
• Operating time and temperature are
affected by the position of the freezer,
the frequency with which the door is
opened, and the temperature of the
room in which it is located.
• When using the appliance for the first
time or after defrosting, set the control
knob to the coldest position for at least
2 hours before inserting the food you
wish to store, and then set it back to the
intermediate position.
• Please, note that when the ambient
temperature is high we recommend to
use a high temperature in the freezer.
• These are the approximate temperatures
for each button position:
• Position 1 (1 to 3): -12~-15ºC
• Position 4 (3 to 5): -18~-20ºC
• Position 7 (5 to 7): -22~-25ºC
Freezing indications
• Prevent
unfrozen
coming into contact with already frozen
products. Always put dry packages in
the freezer to avoid that several of them
freeze together forming a solid block.
• Always prepare food in individual
portions, as they freeze faster.
• To freeze the maximum quantity of food
indicated on the technical data plate,
follow the instructions in the following
section.
• Set the thermostat to the ''7'' position 24
hours before starting to freeze the food.
• Place and distribute the food on the
first shelf directly on the cooling rack
and avoid opening the door more than
necessary; if necessary, open it for the
products
from
