Buffalo CJ564 Manual De Instrucciones página 4

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
EN
Operation
Cooking
1. Close the plates.
Note: It may be necessary to slightly grease the plates with cooking oil before cooking
depending on the foodstuff.
2. Connect the appliance to the mains power supply and set the power switch to "I".
3. Set the thermostat to the desired temperature (50°C-300°C). The HEAT indicator light turns on.
Note: 185°C is suitable for general waffle cooking.
4. When the set temperature is reached, the HEAT indicator light turns Off.
Note: During use, the HEAT indicator light keeps on and off, indicating the set
temperature is being kept.
5. Lift the top plate and place the waffle mix on the bottom plate.
6. Lower the top plate.
Using the timer
The digital timer with audible alarm can be set from 1 second to 19 minutes and 59 seconds. The timer
provides an audible alarm after the set time expires. It provides no electrical control over the unit.
: Press to start timer, press again to stop. The timer will provide an
audible alarm after the set time. The alarm will beep 10 times and the
display will continue to flash until timer is reset (press the
: Press to add extra time.
: Press to reduce time.
: There are a total of 8 programmable timer settings by the factory
before shipment as below:
Program
Factory preset time
To change the length of a program, select the program you want to change by scrolling using the
button.
Adjust the program time by using the
The new program time will be automatically stored.
After use: Set the thermostat to "MIN" and power switch to "O". Then disconnect from the power supply.
Overheating protection
This appliance is featured with an overheat protection. Should the temperature exceed safe levels the
appliance will automatically cut off power.
The thermal Cut-out switch is located on the rear of the appliance. To reset the appliance after a sufficient
cool-down period:
1. Unscrew the reset switch cover.
2. Press the small reset switch down until it clicks, using a blunt pointed instrument.
3. The appliance is now reset and can be used as normal.
4
CJ564_ML_A5_v1_20230913.indb 4
CJ564_ML_A5_v1_20230913.indb 4
1
2
3
4
00:30 01:00 01:30 02:00 02:30 03:00 03:30 04:00
and
button).
5
6
7
buttons. Press
to commence the count-down.
8
2023/9/13 16:35
2023/9/13 16:35
loading