Ruijie Reyee RG-EW1300G Manual Del Usuario página 6

2. Insert one end of the Ethernet cable into the WAN port (yellow) of the secondary
router and connect the other end to the LAN port of the primary router. Power on
the routers and wait for a few minutes until the system status LED turns solid
green. Press the Reyee Mesh button on the primary router to complete wired mesh
pairing. The Wi-Fi name and password of the secondary router are automatically
synchronized with those of the primary router.
Ensure that the secondary router is in its factory settings. If the router has been configured
before, press the Reset button for 10 seconds to restore the router to factory settings before
performing step 2.
FAQs
What should I do if I cannot log in to the router's web interface (192.168.110.1)?
(1) Ensure that the PC's NIC is set to Obtain an IP address automatically.
(2) Ensure that the PC is connected to one of LAN1/2/3 ports on the router, and automatically
obtains an IP address. If not, replace the Ethernet cable.
(3) Close and re-open your browser (Google Chrome is recommended), and enter 192.168.110.1
in the address bar to try again.
(4) Use another web browser.
(5) Use another Ethernet cable or PC.
If the fault persists, restore the router to factory defaults by pressing the Reset button for 10
seconds.
What should I do if I cannot access the Internet event though my router setup is
complete?
(1) Ensure that the Ethernet cable is properly connected as indicated in Connecting the
Router.
(2) Choose Internet on the router's web interface to check the Internet connection type.
If your ISP provides a broadband account and password, select PPPoE and enter the
account and password. If your ISP provides IP address, subnet mask, gateway, and DNS
server, then select Static IP and enter mandatory parameters.
(3) If the fault persists, contact your ISP.
What should I do if I forget the admin password?
Try to enter the Wi-Fi password. If the password is still incorrect, restore the router to factory
defaults.
How do I restore the router to factory defaults?
Use a pin to press and hold the Reset button for 10 seconds until the status LED starts blinking, then
release the button. After the status LED turns solid on, the router is restored to factory defaults
successfully, and you can connect to the router's Wi-Fi network (@Ruijie-sXXXX).
4