Idiomas disponibles
Idiomas disponibles
• Pull the line extending outside of the hub to
release it from the notch.
Small
H°le_h,_
"_''-
Spool
Line in Notch
We recommend all service and adjustments
not listed in this manual be performed by an
Authorized Service Dealer.
CARBURETOR
ADJUSTMENTS
Your carburetor is equipped with limiter caps.
Adjusting the carburetor is a complicated
task. We recommend that you take your unit
to an Authorized Service Dealer. Damage will
occur if you turn the needles beyond the
limiter stops.
IGNITION
TIMING
The ignition timing is fixed, non-adjustable.
SPARK
PLUG
Replace
the spark plug yearly using a
Champion RCJ-8Y plug. Spark plug gap is
Line exit hole
0.025 inches.
TROUBLESHOOTING
TABLE
WARNING:
Always stop unit and disconnect spark plug before performing any of the
recommended remedies below other than remedies that require operation of the unit.
TROUBLE
Engine will no1
start.
Engine will nol
idle properly.
Engine will no1
accelerate,
lacks power,
or dies under
a load.
Engine
smokes
excessively.
Line does not,
advance or
breaks while
cutting.
Line welds
onto spool.
CAUSE
Engine flooded.
Fuel tank empty.
Spark plug not firing,
Fuel not reaching carburetor.
• Carburetor requires adjustment
• Carburetor requires adjustment
• Throttle tdgger screw too
tight,
Air filter dirty.
Spark plug fouled.
Carburetor requires adjustment
• Fuel mixture incorrect.
• Air filter dirty.
• Carburetor requires adjustment
Line improperly routed in head.
Line improperly wound on
spool.
• Line size incorrect.
REMEDY
• See "Starting."
Fill tank with correct fuel mixture.
• Install new spark plug.
Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
• See "Carburetor Adjustments."
• See "Carburetor Adjustments."
• Loosen screw.
Clean or replace air filter.
Clean or replace spark plug; re-gap.
See "Carburetor Adjustments."
• Line size incorrect.
Incorrect spool,
Line is being crowded against
•
material being cut.
Line pulls
• Too little line outside of head.
° Remove spool and pull 4 inches
back into
(10 cm) of line outside of head.
head.
• Line size incorrect.
• Use only 0.065" (1.65 mm) dia. llne.
Empty fuel tank and refill with
correct fuel mixture.
Clean or replace air filter.
See "Carburetor Adjustments."
Check line routing.
Rewind line tightly and evenly.
Use only 0.065" (1.65 mm) dia. line.
Use only 0.065" (1,65 mm) dia. line.
Replace with correct spool.
Cut with tip of line fully extended.
5
