Idiomas disponibles
Idiomas disponibles
Mandrel
Idler Pulleys
Mandrel
Pulley
TO CHECK
AND ADJUST
BRAKE
Your tractor
is equipped
with an adjustable
brake system
which is mounted
on the
right side of the transaxle.
If tractor
requires
more than five (5) feet to
stop at highest
speed
in highest
gear on a
level, dry concrete
or paved surface,
then
brake must be checked
and adjusted.
TO CHECK
BRAKE
1.
Park tractor
on a level, dry concrete
or
paved surface,
depress
clutch/brake
pedal all the way down and engage
parking
brake.
2.
Place gear shift lever in neutral
(N)
position.
The rear wheels
must lock and skid when
you try to manually
push the tractor for-
ward. tf the rear wheels
rotate, the brake
needs to be adjusted
or the pads need to
be replaced,
TO ADJUST
BRAKE
1.
Depress
clutch/brake
pedal all the way
down and engage
parking
brake.
2,
Measure
distance
between
brake oper-
ating arm and nut "A" on brake ro&
3.
If distance
is other than 1-1/2", loosen
jam nut and turn nut "A" until distance
becomes
1-1/2".
Retighten
jam nut
against
nut "A".
4.
Road test tractor
for proper stopping
distance
as stated
above,
Readjust
if necessary.
If stopping
distance
is
still greater
than five (5) feet in highest
gear, further
maintenance
is neces_
sary.
Replace
brake pads or contact
a
Sears or other qualified
service
center.
With Parking Brake "Engaged"
Nut "A"
__Ar_m_
Nut
ting
TO REPLACE
MOTION
DRIVE
BELT
Park the tractor on level surface.
Engage
parking
brake_
For assistance,
there is a
belt installation
guide decal on bottom
side
of left footrest,
BELT REMOVAL-
1.
Remove
mower (See "TO REMOVE
MOWER"
in this section
of manual),
NOTE:
Observe
entire motion drive belt
and position
of all belt guides and keepers.
2.
Remove
belt from stationary
idler and
clutching
idler.
3,
Remove
belt downward
from around
engine
pulley.
4.
Pull belt slack toward
rear of tractor.
Remove
belt upwards
from transaxle
pulley
by deflecting
beIt keeper&
5,
Remove
belt from center span keeper
and pull belt away from tractor.
BELT INSTALLATION
-
1. Carefully
work new belt down between
transaxle
belt keepers
and onto the
input pulley,
2_ Slide belt into the center span keeper.
3.
Pull belt toward front of tractor
and roll
around
the top groove
of engine
pulley.
4.
Install belt through
stationary
idler and
clutching
idler.
5.
Make sure belt is in all pulley grooves
and inside all belt guides
and keepers.
6.
Install mower (See "TO INSTALL
MOWER"
in this section
of manual).
24
