Idiomas disponibles
Idiomas disponibles
12
Troubleshooting
CAUTION
If any of the following conditions occur, turn off the main power supply switch and immediately contact the dealer:
• Switch operation does not work properly.
• The main power fuse often blows out, or the circuit breaker is often activated.
• A foreign matter or water fall indoor the Heat recovery ventilation unit.
• When the Heat recovery ventilation unit does not operate even after the cause of the protective device activation has
been removed.
(The operation lamp and
on the remote controller are flashing. When
and a number are displayed on the remote controller, also inform a qualified service person of the display content.)
• Any other unusual conditions are observed.
Confirm and check
Check code
Indoor unit number
or Heat recovery
ventilation unit
number
Contact information for repairs
You can look for contact information for repairs.
105-EN
and a combination of
,
,
,
When a trouble occurs in the Heat recovery ventilation
unit, the check code and the Heat recovery ventilation
unit number flash on the display of the remote
controller.
* The check code is only displayed during the
operation.
When the check code and Heat recovery ventilation unit
number are displayed, pushing [
Return] opens the
"Check" screen.
In the "Check" screen, push [
Set/Fix] to show the
contacts.
Push [
Menu] to display "Model information".
1
In the "Information" screen, push [
] and
[
] to select "Service information", and
then push [
Set/Fix]
– 53 –
Declaration of Conformity
Manufacturer:
Toshiba Carrier Air Conditioning (China) Co., Ltd.
Building 1, No.60, 21st Avenue and 2nd Floor, Building 3, No.235, 23st Avenue,
Baiyang Street, Hangzhou Economic and Technological Development Area, China.
TCF holder:
TOSHIBA CARRIER EUROPE S.A.S
Route de Thil
01120 Montluel FRANCE
, or
Hereby declares that the machinery described below:
Generic Denomination: Heat recovery ventilation unit
Model / type:
VN-U00151SY-E
VN-U00351SY-E
VN-U00651SY-E
VN-U01001SY-E
Commercial name:
Heat recovery ventilation
Complies with the provisions of the "Machinery Directive" (Directive 2006/42/EC) and the regulations transposing
into national law.
Must not be put into service until the final machinery into which it is to be incorporated has been declared in
conformity with the provisions of Machinery Directive, where appropriate.
Name:
shi zhangxi
Position:
SM, Quality Assurance Dept.
Date:
13 December, 2022
Place Issued:
People's Republic of China
NOTE
This declaration becomes invalid if technical or operational modifications are introduced without the manufacturer's
consent.
VN-U00251SY-E
VN-U00501SY-E
VN-U00801SY-E
106-EN
