Idiomas disponibles
Idiomas disponibles
Phono Mode - Play Vinyl Record
1.
Turn the mode selection knob to PH (Ref.13).
2.
Turn the power & volume control knob clockwise to switch this on and set the
volume. The LED light indicator will flash red.
3.
Place a record on the turntable platter and select the desired speed (33/45/78)
according to the record.
Note: When playing a 45RPM record, please use the included 45RPM adaptor
located in the holder next to the platter (Ref.8).
4.
Remove the stylus protector and elastic band (Keep this to protect the stylus
when not in use).
5.
Open the tone arm clip to release the tone arm (Ref.2). Lift the lift-lever to raise
the tone arm and gently move this to the desired position, over the record.
6.
The turntable will begin to spin when the tone arm is moved toward the record
(when the AUTO STOP switch is ON). Move the lift-lever back to the
7.
down-position to lower the tone arm slowly onto the desired position of the
record to start playback.
8.
If the Auto Stop Control Switch is turned on, the record will stop automatically
when finished. If the Auto Stop Control Switch is turned off, the record will NOT
stop automatically when finished.
Note: The AUTO STOP function applies to most 33RPM vinyl records. However, for
very few vinyl records with an unusual groove pattern, it will stop before it comes to
an end. If this is the case, turn the AUTO STOP switch to the 'OFF' position and then
it will continue playing.
Instructions Guide
EN
9
