Idiomas disponibles
Idiomas disponibles
1
2
EMPTYING THE COLLECTION TANK
WARNING:
BEFORE REMOVING THE POWERHEAD FROM THE COLLECTION TANK.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Disconnect the hose from the vacuum (Fig. 2).
3. Undo the latches and remove the powerhead from the collection tank (Fig. 3). Place powerhead
on a soft, clean surface upside down.
4. Clear all dirt or debris from the collection tank and hose into a proper waste container (Fig. 4).
5. Clean or replace the filters.
6. Check the hose, accessories, and power cord to verify that they have not been damaged.
7. Place the powerhead back on collection tank and secure latches.
IMPORTANT! Clean or change the filter regularly for best performance. ALWAYS USE THE
CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used without the filter, the motor
will burn out and the warranty will be voided. Always keep spare filters on hand.
NOTICE! The filters included are made of high-quality materials designed to stop small dust
particles. The cartridge filter should be used for dry pick-up only. A dry cartridge filter is necessary
to pick up dust. If the cartridge filter is wet, it will clog quickly and be difficult to clean. Handle the
filter carefully when removing it for cleaning or replacing. Check the filters for tears or small holes.
A small hole can let dust pass through and out of the filter. Do not use a filter with holes or tears in
it; replace it immediately.
5
6
STORAGE
Before storing your vacuum, the collection tank should be emptied and cleaned. The cord should
be wrapped then hung on the hook of the carry handle. The hose and accessories should be
stored as illustrated so they can be readily available when needed (Fig. 5 - 7). Store the wet/dry
vacuum indoors.
REPAIRS
Repairs for this wet/dry vacuum should be performed only by qualified service personnel using
only identical replacement parts.
MAINTENANCE
3
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET
7
4
13
