Idiomas disponibles
Idiomas disponibles
● Mark a point (3) on the horizontal line C, 130 (250 optional) mm to the right of the vertical
reference line.
● Repeat this operation on the other side, checking that the two marks are on the same horizontal
line.
Fix the brackets (Optional):
● Drill at the marked points (1) (2) (3), using a ɸ10 mm drill bit.
● Insert the Wall Plugs 11 into the holes (1) (2) (3).
● Fix the hood fixing bracket 20 with 3 screws 10 (5 x 50) supplied with the hood.
● Fix a Chimney fixing bracket 21 with 2 screws 10 (5 x 50) supplied with the hood.
Hook the hood body:
● Open the panel.
● Remove the Metal grease filter using the handles provided.
● Hook the hood body to the bracket 20.
● Level the hood body itself.
● From the inside of the hood body, fix the screws 10 to Wall Plugs 11 at the points (3).
● Fit the filter into the hood.
● Close the panel.
CONNECTIONS
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney
using either a flexible or rigid pipe ɸ 150 or ɸ 120 mm, the choice of
which is left to the installer.
● To install a ɸ 120 mm air exhaust connection, insert the reducer
flange 3 on the hood body outlet.
● Fix the pipe 4 in position using sufficient pipe clamps (not
supplied).
● Remove possible charcoal filters.
Right
Wrong
6
ɸ120
ɸ150
