LED indicator color
Red
Blinking: Interactions (upgrades firmware, reboots router)
Blinking frequently: Restore to factory settings
Blue
Blinking: Pairing mode (Adding a node)
White
Steadily illuminated: Stable network connection
Blinking: Poor mesh connection
Orange
Steadily illuminated: No Internet connection
Website:
Email:
www.mercku.com
��
Need help:
www.mercku.com/help
This guide provides a brief introduction to Mercku hardware and software. The images, steps, and descriptions are
purely for illustrative purposes and may not accurately represent your personal experience. Please note that this guide
is for informational purposes only, and we cannot guarantee the accuracy or completeness of the information
provided. Additionally, please be aware that updates to the content may happen without prior notice.
FCC ID: �APR�-M�S
This device complies with Part �� of the FCC rules. Operation is subjected to the following two conditions:
(�) this device may not cause harmful interference, and (�) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void your authority to
operate the equipment.
The device for operation in the band ����-���� MHz is only for indoor use to reduce the potential for harmful
interference to co-channel mobile satellite systems;
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
(�) This device may not cause interference; and
(�) This device must accept any interference, including interference that may cause undesired operation of the device.
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. The distance
between user and products should be no less than ��cm.
L'appareil dans la bande ����-���� MHz ne fonctionne uniquement qu'à l'intérieur afin de réduire le risque
d'interférence nuisible aux systèmes mobiles par satellite dans le même canal;
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences
et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :
(�) Cet appareil ne doit pas provoquer d'interférences; et
(�) Cet appareil doit accepter toute interférence, y compris les interférences susceptibles de provoquer un
fonctionnement indésirable de l'appareil.
La distance entre l'utilisateur et les produits ne doit pas être inférieure à �� cm.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part �� of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device meets the exemption from the routine evaluation limits in section �.� of RSS ��� and compliance with
RSS-��� RF exposure, users can obtain Canadian information on RF exposure and compliance.
Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section �.� de RSS ��� et la conformité à
l'exposition de RSS-��� rf, utilisateurs peut obtenir l'information canadienne sur l'exposition et la conformité de rf.
��