Idiomas disponibles
Idiomas disponibles
TO REPLACE BELT
1, Slide washers
and end caps onto
agitator assembly,
2. Install new
belt over motor
drive, then
over brush
sprocket.
NOTE: Use
belt #20-5201.
In Canada,
#20-4097&
End Cap
Motor
Brush
Drive
3, Place agitator
assembly back into
Power-Mate ® ,
4. Reinstall
agitator
cover by lin-
ing up the
front tabs
and slots
and rotating
downward
until the
latches
Agitator Cover
snap into place.
:[
5, Line up
front of
cover and
base_ Rest
cover on
front edge of
base as
shown,
Cover
Base
i
'
io
_o
6. NOTE: On dirt
>
sensor models
be sure that the
board is upright
and the wires are
tucked back as
k4
shown.
:::::3
Top View
rim
7, Rotate cover
back, Press cover
firmly until side
and rear tabs snap
into placer Turn
Power-Mate ®
upside down and
replace two (2)
1. Remove Power-Mate e cover as shown in
BELT CHANGING
AND AGITATOR CLEAN-
ING section.
2. Push in and turn
bulb counterclock-
wise, then pull out
to remove.
PUSdhTnurn I
3. Push in and turn
bulb clockwise,
to
replace°
Bulb must
not be higher than
15 Watts (130 Volts),
4. Reinstall
Power-Mate e cover as shown in
BELT CHANGING
AND AGITATOR CLEAN-
ING section,
NOTE: Use bulb #20-5240.
tn Canada,
#596!81.
19
